This will explain how I made a decorative letter using twigs/sticks/kindling, whatever you want to call them.
I originally saw the idea on Pinterest, pinning it but never opening it, so I kind of took my own approach. This is the picture linked to the pin:
I was already at Walmart when I remembered they had wooden letters, so I went to the craft aisle and wah-lah! There were to different sizes, the larger of the two only $0.50 more so I went with the larger. I also didn’t want to have to find itty bitty twigs and wanted the option of some variety with what I found in our tree line.
This is the type of letter I got at Wally World. (I didn’t take a picture, so I got one off of their website). It was $1.97, I believe.

I also got Matte Modge Podge. It was my first time buying this stuff, so I just got Matte hoping it wouldn’t be really glossy and shiny, that way my twigs look normal.
I got a paint brush (a normal paint brush about an inch wide), but I have seen people use foam brushes with modge podge a lot. Maybe next time.
The Work:
I did this all on my kitchen table, over paper towels (I wanted to use newspaper but I couldn’t find any). Clean up was fairly easy, and I kept a wet paper towel next to me for my fingers and for any glue that got on the table.
(I didn’t take any pictures while I did this, oops!)
In the picture below, you will notice I used larger pieces of broken off tree bark. I didn’t plan on using park when I originally decided to do this project, but when I saw it on the ground while twig hunting I figured it would give my C some character, and also take up space 🙂

I laid out my bark on where I wanted it to go onto my C. I painted my podge onto the area where I was going to put it, then onto the underside of my bark piece, and finally I applied the bark. I did this one by one so I wouldn’t get ahead of myself. I did press on the bark for 30-60 seconds, sometimes hearing a little crack because most of them were a little curved. No worries.
I then grabbed some of my twigs and broke them up. I tried not to use the same ones around each other. As you can see, some are mossy, some are darker, thinner, etc. So I’d variate from using from my pile that I broke up, and looking in my plastic bag I had put them in.
When gluing the twigs, I’d put a decent amount of podge where I wanted to place it, and then I’d put podge on the twig also. Just as I did with the bark, I’d press on the twig for a little so that it stays in place. This became more prominent as I went on and started putting twigs on top of others.
Once all were in place, I found or made very small pieces of twig and bark to put in little crevices on the edges that way you couldn’t see the original wood.
The next day, once all my glue dried, I took another brush and the modge podge and went over my twigs lightly just to make sure everything stays in place. The picture was taken after I tried to get some glue out that gathered up in holes and wasn’t fully dried yet, so I still have some cleaning up to do in those small areas.
This was honestly one of the easiest projects I’ve tried, and cheapest too!


